Servo Mounting Plate
Lower suspention spacer
Two 2-56 button head screws
Two 2-56 nuts
|  |
| Bolt the spacer on so the half drilled holes are on the same side. |  |
| Get your mini z servo and put the square in the square hole. You may need to file the radius on the mounting plate for a better fit. |  |
| Put your front king pins in the half drilled holes. You will need to press them in with needle nose pliers. |
|
| Get the 2-56 corse thread button head screws or use screws from the miniz. Also need the upper spacer and a upper suspention arm. |
|
| Before you put on the upper suspention arm put your steering blocks and front springs on the king pins. |
|
| Besure the half drilled holes in the arm face down. |
|
| Screw the upper suspention arm into the servo and make sure the king pins are in the upper arm half drilled holes. |
|
